有沒有人會用paypal，然後剛好想敗水冷頭的?
- 主題發起人 luke929
- 開始日期
訂購網頁上說：第一批已經賣完，下一批預計是十月底
或十一月初。
澳幣200以下建議使用paypal，另外加收3%匯兌處理費
用...；澳幣200以上收個人支票。
所以...，有點奇怪。
我看魔王還是去多多顯靈去haunt linny比較快啦。
或十一月初。
澳幣200以下建議使用paypal，另外加收3%匯兌處理費
用...；澳幣200以上收個人支票。
所以...，有點奇怪。
我看魔王還是去多多顯靈去haunt linny比較快啦。
這是之前公怖的數據
AthlonXP2800+ @ an actual 2.55GHz/1.95v
Test procedure is a freshly cleaned mount, startup, thermal paste settling cycle consisting of BurnK7 for 30 minutes and then turning computer off for 30 minutes. Then system is run with BurnK7 to equilibrium. Basically been testing near non-stop for the last 3 days.
Using a thermal probe under the CPU, with the socket area insulated from air. This is tested to work pretty well as blasting a high speed fan at the socket area vs no fan, results in less than a 0.5C variation in reported temperatures. Testing conditions are kept as identical as possible, with normal ~1C variations in room temperature across the test set. Each block mounted 3 times, best result taken.
Pumping power is set to that which is about equivalent to a LaingD4 @ 12v, or a Danner Mag 3, or an Iwaki MD15-R, or roughly around about 2.5mH2O pumping pressures and varying on the block used.
Value reported is (CPU probe - water probe) delta in degrees C.
+22.2 Silverprop Cyclone 3 (the open block pure-impingement one)
+20.7 Storm/G1
+19.4 White Water
+18.8 Storm/G3
+18.6 Cascade SS
+17.7 Storm/G4
不過cascade ss跟G4的數據後來cathar有說他弄錯了...但沒看到詳細的數據
只知道G4比cascade ss低0.5度
詳細討論串
AthlonXP2800+ @ an actual 2.55GHz/1.95v
Test procedure is a freshly cleaned mount, startup, thermal paste settling cycle consisting of BurnK7 for 30 minutes and then turning computer off for 30 minutes. Then system is run with BurnK7 to equilibrium. Basically been testing near non-stop for the last 3 days.
Using a thermal probe under the CPU, with the socket area insulated from air. This is tested to work pretty well as blasting a high speed fan at the socket area vs no fan, results in less than a 0.5C variation in reported temperatures. Testing conditions are kept as identical as possible, with normal ~1C variations in room temperature across the test set. Each block mounted 3 times, best result taken.
Pumping power is set to that which is about equivalent to a LaingD4 @ 12v, or a Danner Mag 3, or an Iwaki MD15-R, or roughly around about 2.5mH2O pumping pressures and varying on the block used.
Value reported is (CPU probe - water probe) delta in degrees C.
+22.2 Silverprop Cyclone 3 (the open block pure-impingement one)
+20.7 Storm/G1
+19.4 White Water
+18.8 Storm/G3
+18.6 Cascade SS
+17.7 Storm/G4
不過cascade ss跟G4的數據後來cathar有說他弄錯了...但沒看到詳細的數據
只知道G4比cascade ss低0.5度
詳細討論串
