密碼一直錯誤不能進去
以下是機器的解除方法 但是我都看不懂...
3COM的分享器
原文如下..
Forgotten The System Password
--------------------------------------------------------------------------------
If you've not set a System password before, the unit will accept the default password "admin". Remember that all passwords are case sensitive.
If you've changed the System password but cannot remember it, then the following procedure can be used to reset the whole unit back to the factory defaults. This will set the system password back to "admin" but unfortunately, it will also clear any configuration you may have already entered. We recommend you print this page before proceeding.
1. Unplug the power, and remove the all cables from the gateway.
2. Using an RJ45 cable, connect the gateway's Cable/DSL port to one of the LAN ports.
3. Apply power to the unit
4. The Alert LED will start to flash. Wait until the flash rate changes to 2 seconds on, 2 seconds off, continuously.
5. Unplug the power and re-connect your network as before.
6. Apply power.
7. The unit will now have the default IP address of 192.168.1.1 and subnet mask of 255.255.255.0. You should now follow the steps in the Installation Guide to re-install your gateway.
以下是機器的解除方法 但是我都看不懂...
3COM的分享器
原文如下..
Forgotten The System Password
--------------------------------------------------------------------------------
If you've not set a System password before, the unit will accept the default password "admin". Remember that all passwords are case sensitive.
If you've changed the System password but cannot remember it, then the following procedure can be used to reset the whole unit back to the factory defaults. This will set the system password back to "admin" but unfortunately, it will also clear any configuration you may have already entered. We recommend you print this page before proceeding.
1. Unplug the power, and remove the all cables from the gateway.
2. Using an RJ45 cable, connect the gateway's Cable/DSL port to one of the LAN ports.
3. Apply power to the unit
4. The Alert LED will start to flash. Wait until the flash rate changes to 2 seconds on, 2 seconds off, continuously.
5. Unplug the power and re-connect your network as before.
6. Apply power.
7. The unit will now have the default IP address of 192.168.1.1 and subnet mask of 255.255.255.0. You should now follow the steps in the Installation Guide to re-install your gateway.