保锐EG651AX-VH(W)拆解

christie_zhou

初級會員
已加入
2/1/09
訊息
20
互動分數
0
點數
0
最近看了不少PSU的贴,学习了不少东西,特别是从狼大那里。。
察看自己的PSU后开始在网路上查资料,结果关于这个型号的Review很少,
终于忍不住开始拆机。。

手边没有相机,不能上图,各位谅解。;rr;

EMI电路为标准两级

一次侧滤波电容 日立330U 400v 1颗

一次侧整流 两颗BYC10-600,两颗BT152-600可控硅,

主动 PFC MOSFET 这个没有拆开看,应该是1颗英飞凌SPW17N80C3或者东芝2sk2746,
PFC 整流 BYC10-600。

PFC芯片 UCC3817连续电流式控制芯片。

PWM MOSFET 1颗英飞凌SPW17N80C3 (17A)以单端正激拓扑推动12v变压器,
1颗东芝2sk2746 (7A)以单端正激拓扑推动5v、3v变压器,
1颗东芝2sk2750 (3.5A)以单端反激拓扑推待机变压器

PWM 芯片 TI UC3842N,好像有三只芯片

这个PSU用了两个主变压器,1个供12v输出,1个供5v,3v输出.两个变压器大小一样。
5v与3v各自有独立的线圈绕组,3v输出好像用了磁放大稳压。

二次侧整流 12v用两颗S60SC6M并联输出,5v用两颗S30SC4M并联输出,3v与5v相同

风扇温控使用TI 393,过压过流保护电路 点晶的PS222

二次侧滤波,全部为CTC电容。散热风扇为两只三洋8mm风扇推拉式,温控转速。

因为不懂电路,就只能看到这么多了。;rr;

这里就有几个问题请教狼大,望不吝赐教,
1、这只PSU很少见到review,是因为太老型号还是因为这个型号在保锐产品中比较失败呢?
2、看HARDWARE SECRETS后,觉得其用料应该不是太差,但标称效率却只有75% min, 70%@full load,
主要原因是因为使用单端正激拓扑而不是双管正激的缘故吗?还是电路设计上的问题。不过GALAXY EL1000也是用的单端正激,结果还是拿了白牌的。
3、PFC线圈除主绕组外还有1个细铜线绕组,不知是什么用途,同样12v输出滤波线圈上也有1个额为的绕组。请教那是做什么用的呢?
4、一次侧整流这点就比较奇怪,不知是不是单相半可控全桥整流方式,为什么没有用全桥?
5、这个系列还有EG851AX-VH(W),从网路上照片看比EG651AX-VH(W)多了个一次测主滤波电容,好像是2个330u的并联。别的不同就不清楚了。。

第一次拆电源,有不对的地方请谅解。很多疑问,还请各位大大释疑。。。谢谢
 

christie_zhou

初級會員
已加入
2/1/09
訊息
20
互動分數
0
點數
0
- -! 贴错位置啦??会被移出。。 :-(
 

zexinfinite

一般般會員
已加入
2/1/09
訊息
72
互動分數
0
點數
0
描述的好清楚~
但是還是看圖比較有感覺~
 

christie_zhou

初級會員
已加入
2/1/09
訊息
20
互動分數
0
點數
0
?不能上本地图。。 - -!










;em44;
 
最後編輯:

hoodlum1022

Lu-Kung
已加入
10/18/08
訊息
675
互動分數
0
點數
0
年齡
33
這個笑話已經回鍋了喔:PPP:
 

kisy33151

一般般會員
已加入
1/27/09
訊息
75
互動分數
0
點數
0
暈倒,用桌面當連結只有自己能看到其他人沒辦法看到的
 

christie_zhou

初級會員
已加入
2/1/09
訊息
20
互動分數
0
點數
0
终于搞定。。。最后一张是EG851AX-VH的图,看第四张图上的电容空位,还有第六张图,可以看见比EG651AX-VH多了个电容。
补充下,变压器旁的小板上是PWM控制板,输出线旁的小板是输出监控保护电路板。
外壳用的铝质材料,散热器都直接固定在外壳上辅助散热(除了PFC MOSFET的散热片),风扇温控探头固定在二次侧散热器上,在12v整流管旁边。
三个输出电感中12v用的是黑色磁芯,5v、3v用的是绿色磁芯。
待机变压器旁边的线圈从走线上看是3v电路的磁放大线圈。
另外在PWM MOSFET 与变压器中间还有两个黑色的线圈,不知道是做什么用的,在单端正激电路中好像没有见到这么个电感的。。。。 - -!
还有就是4路12v是VIRTUAL的,实际只是接了4个小电阻作过流侦测,并不是独立的。。
EMI电路中有个X电容和一对Y电容是焊在AC输入插座上的,并不在电路板上。
这颗PSU的3v和5v输出是够大了,12v就还有点不够,因为是老型号的缘故吧。。郁闷。这样上HD4850 crossfire就不够了 。。。而且也说不上安静 。
 

christie_zhou

初級會員
已加入
2/1/09
訊息
20
互動分數
0
點數
0
这颗PSU没有开机时的电流声,但是SPEC 中效率太低了,多交不少电费了。。。
没有办法实测转换效率,但想来如果高的话保锐官方也不会那么标吧。。额
这是SPEC 链接,这个效率也叫 high efficiency,, = =!
http://www.enermaxusa.com/catalog/p...id=67&osCsid=647fd5808dbc5f08dcab0a2ff2e98c5f

- specifications
Type: ATX
Maximum Power: 550W
Active PFC: Yes
Power Good Signal: 100-500ms
Hold-up Time: 18ms min. at 100~230V AC full load
Efficiency: 75% min.
Over Voltage Protection: +3.3V: 3.9V~4.5V; +5V: 5.7V~6.5V; +12V: 13.3V~14.5V
Overload Protection: +3.3V: 55A max, +5V: 48A max, +12V1.2.3.4: 20A max
Input Voltage: 90V~264V AC
Input Frequency Range: 47-63Hz
Input Current: 10A
Output: +3.3V@1.5/36A, +5V@5/36A, +12V@60A, -12V@0.8A, +5VSB@2.7A
MTBF: 100K hours at 25
Approvals: UL cUL VDE DEMKO NEMKO SEMKO FIMKO
I/P Voltage rating 90V~264V AC(Full Range)
Current rating 9A
Frequency 47Hz~63Hz
Inrush current 25A max 240V (during cold start)
O/P DC
Voltage Ripple & Noise Total
Reg. Output current rating
Load Range 1 (Min. / Max.) Load Range 2 (Min. / Max.)
+3.3V 50mV +5/-3% 1.5A /36A 0.5A /9A
+5V 50mV +5/-4% 5A /36A 2A / 7A
+12V1 120mV +5/-4% 1.5A / 14A 0.5A / 5A
+12V2 120mV +5/-4% 1.5A /16A 0.5A / 4A
+12V3 120mV +5/-4% 1.5A /16A 0.5A / 6A
+12V4 120mV +5/-4% 1.5A / 14A 2A /5A
-12V 120mV +9/-5% 0A / 0.8A 0A / 0.5A
+5Vsb 50mV +5/-3% 0.1A / 2.7A 0.1A / 2A
+3.3V & +5V 200W
Max. Combined +12V 420W(35A)
Total Power 550W
Hold up time 18ms min. at 100~230V AC full load
Over Power Protection 105%~140% of max load
Under Voltage/Short Circuit Protection +3.3V: 2.6V min, 2.9V max
+ 5V : 4.1V min, 4.5V max
+ 5Vsb:4.1V min, 4.5V max
+12V1.2..4 : 9.5V min, 10.5V max
Over Voltage Protection +3.3V: 3.9V~4.5V
+ 5V : 5.7V~6.5V
+12V:13.3V~14.5V
Over Current Protection +3.3V:55A max
+ 5V : 48A max
+12V1.2.3.4 :20A max
Efficiency 70% min. at full load
Cooling Air convection by +12V DC fan
Operation Temperature 0篊 ~45篊 for full rating of load, 50篊 for 75% of rated load, decrease to zero Waltts O/P at 70篊
Storage Temperature -20篊 ~80篊
Humidity Operating: to 85% relative humidity , non-condensing At 25篊
Storage : to 95% relative humidity , non-condensing At 50篊
MTBF 100K hours at 25篊, 70% full rated load, 115VAC Input
EMC EN55022 CLASS BEN61000-3-2EN 61000-3-3EN 61000-4-2EN 61000-4-3EN 61000-4-4EN 61000-4-5 EN 61000-4-6EN 61000-4-8 EN 61000-4-11 FCC Part 15 & Part 2 and CNS 13438 Class B
Safety UL cUL VDE DEMKO NEMKO SEMKO FIMKO
Dimension W150 x H86 x D180 (mm)

features
- high output
550W output provides sufficient power for server system.

- quad +12V Rails
Independent 12V rails supply to MB/CPU and drives in order to provide stable and clean current to noise-sensitive devices, such as: CPU, add-on cards.Meet UL 240VA safety requirements. It also separate the motherboard rails and video card rails to ensure maximum power to your PCI Express video card.

- high efficiency
High efficiency is achieve by using using high quality components and the skills of our designer to maximizes your power supply output and minimize wasted power. Efficiency is the measure of how much of the 100% power going in to the PSU is being used up and the unused power dissipate into heat through the heatsink. Lower efficiency means that more power is being wasted and also the PSU will generate more heat. .

- dual fans
Dual fan design,with high quality and long MTBF Sanyo Denki coolers, offers the best heat ventilation effect.

- compatibility
Effectively prevents electro-magnetic pulse leaking from switching power supply to appliances that are being attached to the same power source, i.e. AC wall plug..

- protection
Enermax has one of the highest protection standard on the market today, due to our advance design we offer the following type of protections:

OCP -Over Current Protection, UCP -Under Current Protection, OVP - Over Voltage Protection, OLP -Over Load Protection, OTP - Over Temperature Protection, SCP - Short Circuits Protection.
 
▌延伸閱讀